User manual

RIGOL Chapter 16 Remote Control

MSO2000A/DS2000A User’s Guide

16-2

Remote Control via USB

1. Connect the device

Connect the oscilloscope (USB DEVICE) with your PC using a USB cable.

2. Install the USB driver

This oscilloscope is a USB-TMC device. After you connect the oscilloscope to the

PC and turn both on for the first time (the oscilloscope is automatically

configured to USB interface; at the same time, make sure that Utility  IO

Setting  USB Device is set to "Computer"), the Found New Hardware

Wizard as shown in the figure below is displayed on the PC. Please install the

“USB Test and Measurement Device (IVI)” driver following the directions in the

wizard. The steps are as follows.