User Manual

RIGOL 11 Waveform Record
MSO4000/DS4000 User’s Guide
11-2
Waveform Record
Waveforms from all the channels currently turned on will be recorded during
waveform record.
Press Record  Mode and use to select “Record” to open the waveform record
operation menu.
1. End Frame
Press End Frame and use to set the desired number of frames to be
recorded. The number of frames available is related to the memory depth
currently selected.
2. Record Operation
Waveform recod can be realized via the menu or the shortcut buttons at the
front panel.
Menu Front Panel
Press Operate and select “●” to
start recoding.
Press ; the backlight goes on (in red)
and starts to flash, indicating that the
record is started.
When the record is finished, “●”
changes to “■” automatically. You
can also select “■” manually.
When the recod is finished,
goes off
automatically and
goes on (in orange).
You can also press
directly.
3. Interval
Set the time interval between the frames in waveform record and the range
available is from 100 ns to 10 s.
4. Maximum Number of Frames
The menu shows the maximum number of frames that can be recorded based
on the current oscilloscope settings.
Waveform memory capacity is fixed. More points per frame results in a smaller
number of waveform frames. Thus, the maximum end frame of waveform record
is decided by the “Memory Depth” setting currently selected. Please refer to the
instruction in “
LA Sample Rate” to select the desired memory depth.