Data Sheet

RIGOL 15 Remote Control

MSO4000/DS4000 User’s Guide

15-2

Remote Control via USB

1. Connect the device

Connect the oscilloscope (USB DEVICE) with your PC using a USB cable.

2. Install the USB driver

This oscilloscope is a USBTMC device. Assuming that your PC has already been

installed with Ultra Sigma, after you connect the oscilloscope to the PC and

turn both on for the first time (the oscilloscope is automatically configured to

USB interface), the New Hardware Wizard as shown in the figure below is

displayed on the PC. Please install the “USB Test and Measurement Device”

driver following the directions in the wizard. The steps are as follows: