Data Sheet
RIGOL 10 Pass/Fail Test
MSO4000/DS4000 User’s Guide
10-2
To Enable Pass/Fail Test
Press Utility Pass/Fail Enable Test to select “ON”. Note that when the time
base is in X-Y mode, the Pass/Fail test function can not be enabled.
To start testing, press Enable Test and select “ON”. Then, press Operate to select
“
” to start testing and select “■” to stop testing. The figure below is the test
interface:
You can select the source, create mask as well as save and load the test mask. For
details, please refer to the following introductions.