Instructions

RIGOL Chapter 6 Operations and Measurements
6-18 MSO7000/DS7000 User's Guide
 Press More  Invert to enable or disable the inverted display function of the
waveform.
 Press More  Label to set the label for math operation results. For details,
refer to descriptions in "Math Operation Label".
Exp
Calculates the exponential of the selected source point by point and displays the
results.
Press Math  Math1  Operator to select "Exp":
 Press Operation continuously to enable or disable the "Exp" operation function.
 Press SourceA, and rotate the multifunction knob to select the channel for
SourceA. Then press down the knob to select the channel. You can also press
SourceA continuously or enable the touch screen to select the channel. The
available channels for SourceA are CH1, CH2, CH3, and CH4.
Note: Only the channels that have been enabled currently can be selected.
 Press Offset to set the vertical offset of the operation results. For setting
methods, refer to the descriptions in "Parameter Setting Method". You can
also directly rotate Wave Vertical POSITION or enable the touch screen
to adjust the vertical offset.
 Press Scale to set the vertical scale of the operation results. For setting methods,
refer to the descriptions in "Parameter Setting Method". You can also
directly rotate Wave Vertical SCALE or enable the touch screen to adjust
the vertical scale.
 Press AutoScale to adjust the vertical scale and offset of the operation results
to an optimal value based on the current configuration, so as to better observe.
 Press More  Invert to enable or disable the inverted display function of the
waveform.
 Press More  Label to set the label for math operation results. For details,
refer to descriptions in "Math Operation Label".
Abs
Calculates the absolute value of the selected source and displays the results.
Press Math  Math1  Operator to select "Abs":
 Press Operation continuously to enable or disable the "Abs" operation function.
 Press SourceA, and rotate the multifunction knob to select the channel for
SourceA. Then press down the knob to select the channel. You can also press