User manual

Chapter 2 Command System RIGOL
RSA3000 Programming Guide 2-111
 [:SENSe]:OBWidth:MAXHold:STATe*
 [:SENSe]:OBWidth:PERCent*
 [:SENSe]:POWer[:RF]:ATTenuation
 [:SENSe]:POWer[:RF]:ATTenuation:AUTO
 [:SENSe]:POWer[:RF]:GAIN[:STATe]
 [:SENSe]:POWer[:RF]:MIXer:RANGe[:UPPer]
 [:SENSe]:SIGCapture:2FSK:AMPDown
*
 [:SENSe]:SIGCapture:2FSK:AMPUp*
 [:SENSe]:SIGCapture:2FSK:MARK1:FREQ*
 [:SENSe]:SIGCapture:2FSK:MARK1:SWitch[:STATe]*
 [:SENSe]:SIGCapture:2FSK:MARK2:FREQ*
 [:SENSe]:SIGCapture:2FSK:MARK2:SWitch[:STATe]*
 [:SENSe]:SIGCapture:2FSK:MAXHold[:STATe]*
 [:SENSe]:SIGCapture:2FSK:PEAKAmp?*
 [:SENSe]:SIGCapture:2FSK:PEAKFreq?*
 [:SENSe]:SIGCapture:2FSK:PF?
 [:SENSe]:SIGCapture:2FSK:PFSWitch[:STATe]
*
 [:SENSe]:SIGCapture:2FSK:RESet*
 [:SENSe]:SIGCapture:2FSK:SIGNal*
 [:SENSe]:SWEep:POINts
 [:SENSe]:SWEep:TIME
 [:SENSe]:SWEep:TIME:AUTO
 [:SENSe]:SWEep:TIME:AUTO:RULes
 [:SENSe]:TOI:AVERage:COUNt
*
 [:SENSe]:TOI:AVERage[:STATe]*
 [:SENSe]:TOI:AVERage:TCONtrol*
 [:SENSe]:TOI:FREQuency:SPAN*
 [:SENSe]:TPOWer:AVERage:COUNt*
 [:SENSe]:TPOWer:AVERage[:STATe]*
 [:SENSe]:TPOWer:AVERage:TCONtrol*
 [:SENSe]:TPOWer:LLIMit*
 [:SENSe]:TPOWer:MODE*
 [:SENSe]:TPOWer:RLIMit*
Remarks: The commands with * are only available for the RSA3000 series that has been installed with
advanced measurement kit (AMK) option.