Instructions

RIGOL Chapter 2 Command Systems for GPSA and RTSA Modes
2-42 RSA3000E Programming Guide
:CONFigure:ACPower
Syntax
:CONFigure:ACPower
Description
Sets the analyzer to be in the ACP measurement state.
Remarks
This command is only available for GPSA mode.
Running this command will discontinue the current measurement and restore the specified measurement of
the instrument to the default factory state.
After changing any measurement setup, running the
:READ Commands will initialize the measurement, and
you do not have to set the measurement to the default.
:CONFigure:CNRatio
Syntax
:CONFigure:CNRatio
Description
Sets the analyzer to be in the CNR measurement state.
Remarks
This command is only available for GPSA mode.
Running this command will discontinue the current measurement and restore the specified measurement of
the instrument to the default factory state.
After changing any measurement setup, running the
:READ Commands will initialize the measurement, and
you do not have to set the measurement to the default.
:CONFigure:DENSity
Syntax
:CONFigure:DENSity
Description
Sets the analyzer to be in the Density measurement state.
Remarks
This command is only available for RTSA mode.
Running this command will discontinue the current measurement and restore the specified measurement of
the instrument to the default factory state.