Owner`s manual

3. Installation
CAUTION
The machine must not be plugged in and the power switch must
be in the OFF position until assembly is complete.
3.1 UNINSTALL THE OLD SWITCH PLATE
- Unscrew the 3pcs pan head screw A-Fig.1, and then unscrew
the small pan head screw B-Fig.1. Then take out the switch
plate.
3.2 ATTACHING SPUR CENTER ON THE
HEADSTOCK
- Insert spur center, with a No.2 Morse Taper shank, into the
headstock spindle. (See FIG.2)
FIG. 1
A
A
B
B
3.2 UNINSTALL THE TERMINALS
- Unscrew the grounding terminal (A-FIG.2) and uninstall
other terminals(B-FIG.2).
- Remove the black plastic box (C-FIG.2).
FIG.2
A
B
B
FIG.3
3.3 UNINSTALL STRAIN RELIEF
- Uninstall the two strain relief cord holders on the back of
headstock.
C
3.1 UNINSTALL THE OLD SWITCH PLATE
- Unscrew the three pan head screws (A-FIG.1) to loosen
the plate from headstock.
- Unscrew the two small pan head screws (B-FIG.1) to
loosen the switch plate from inner black box.
FIG.1
A
A
B
B
6