Owner`s manual

3.7 UNINSTALL OLD SPINDLE PULLEY

- Engage the spindle lock to stop spindle from rotating.

- Unscrew the socket screw (A-FIG.7) to take out handle.

Note: Handles on older units are threaded onto the shaft

end and held into place with one set screw. Loosen set

screw and spin handle clockwise (reverse thread).

- Older units use a snap ring to set the handle depth

in front of the spindle pulley. Remove snap ring before

removing spindle pulley.

- Unscrew the socket screw (B-FIG.7) to take out the old

spindle pulley.

FIG.7

FIG.8

3.8 INSTALL NEW SPINDLE PULLEY

- Slide the new spindle pulley onto the spindle shaft making

sure the large pulley is toward the handle end of the

spindle. A-FIG.8.

- Use a straight edge or install the drive belt to help align

the spindle pulley to the motor pulley. Tighten the two

socket screws on the spindle pulley to lock it into position.

- Install the end handle and lock it.

3.9 INSTALL THE NEW PC BOARD BOX

- Remove the PC board from the PC board box by

loosening the two phillips head screws (A-FIG.9A).

- Install the cable of new motor according to the old route

and slide the cables through the new PC board box

(A-FIG.9B).

FIG.9B

FIG.9A