Owner`s manual

3.10 CONNECT TERMINALS

- Connect the white wire of the motor cable to M+ position,

and connect the black wire of the motor cable to M-

position.

- Connect the bare copper end of the black wire (white

shown for clarity) of the power cable to the AC-IN position.

Note: It is necessary to trim the bare copper wire leaving

1/4" exposed.

M+

M-

Ac-In

FIG.10

3.11 INSTALL PC BOARD TO BOX

- Install the PC board to new box as shown in FIG.11.

- Slide the PC board box into into the lathe head.

- Due variations in casting and powdercoat thickness it may

be necessary to enlarge the switch box opening slightly.

Note: On some units it may be necessary to remove the

strain relief plate on the rear of the headstock to prevent

the wires from being pinched to allow clearance as the PC

board box is installed.

FIG.11

FIG.12

3.12 INSTALL NEW SWITCH PLATE

- Uninstall the switch from old switch plate.

- Install the switch into the new switch plate.

- Install the speed control knob into the new plate and lock

it with nut (A-FIG.12).

- Install the knob cap (B-FIG.12).