User guide

Maintain the AutoPrinter

Prism printer

To align your Prism printer, use the following instructions.

# Required tools:

• T25 Torx screwdriver

• 5/32” Allen wrench

1. Power on the AutoPrinter.

 Note: If the Prism power switch is in the on position, power on both the printer and the

power switch.

AutoPrinter by pressing the AutoPrinter

2. Wait for the unit to complete initialization.

3. Prepare the unit for alignment.

a. Manually slide the lift arm to the top of

the AutoPrinter.

b. To place a disc in the gripper, push

the disc up into the gripper while

pressing the disc release button.

c. Release the button. The gripper holds

the disc.

d. Press the printer button to open the

printer tray.

Lift

Arm

Gri

Disc Release Button

4. Align the printer.

a. Slowly slide the lift arm

down until the disc just

touches the print pad.

Lift

Arm

Side to Side

Ali

nment

Pad

Holding Pins

Printer

Button

110656_I 9