User guide

Operate the Everest printer

110632_L 7

- driver was previously installed, remove

- To install the Everest printer driver on the PC, you must have administrative

isc drive.

er Setup.exe file.

4. Follow the prompts to complete the installation.

Operate the Everest printer

This section provides the information needed to use your Everest printer.

Powering on and off the Everest printer

The Everest printer does not have a power switch:

 Note: The printer will go into sleep mode if it is idle for more than 30 minutes. When this

occurs, the printer will take 2-3 minutes to warm up after a job is sent to the printer.

• If the Everest printer is on an autoloader, the printer is powered on when the autoloader is

powered on. To power off the Everest printer, power off the autoloader.

• If the Everest printer is a standalone printer, connect the power cord from the Everest printer

to a power outlet to power on the printer. To power off the Everest printer, disconnect the

power cord.

Installing the Everest printer driver

Before printing, you must install the printer driver. If your Rimage Everest printer was included

with an autoloader that has an embedded PC or a control center, the Everest printer driver

is already installed.

Before you begin:

1. Connect the USB cable.

2. Connect the power cord.

3. Ensure that the Everest printer is powered on.

 Note: If the Everest printer is a standalone printer (not on an autoloader), the Everest

printer will power on when you connect the power cord. If the Everest printer is on an

autoloader, the Everest printer will power on when you power on the autoloader. For

more information, refer to ‘Powering on and off the Everest printer’ on page

4. If the Found New Hardware Wizard opens, select Cancel.

5. On the computer, close all applications.

Installing the Everest printer driver on Windows

Important: If an older version of the Everest printer

the previous version before installing the new one.

Important!

privileges.

1. Place the software CD in the PC d

2. Navigate: Start > Run > Browse.

3. From the software CD, select the Everest printer driv