Technical data

8.4 Oscillator system

Work on the oscillator system (S1) only if the sup-

ply voltage is switched off! High-voltage!

Avoid contact with the RF socket (RF1) of the

hand welding unit.

Do not connect any measuring device to the RF

socket of the hand welding unit!

The built-in transducer contains an electrical

charge even after the generator has been switched

off!

8.5 Screw connection

After the horn has been in operation for a longer

period of time, disconnect it according to the

instructions in chapter 7 “Retooling” and check it

for cleanliness.

Tightening torque: 30 – 40 Nm

Black spots on the interface K1 can be cleaned as

follows:

1. Clean with an oil-free cleaning agent and a

cotton or paper cloth.

2. If the surface is uneven or has grooves, please

contact the appropriate service location.

HF1