Installation Guide

Video Doorbell
Setup & Installation
Step 1
Download the Ring app
The Ring app will walk you through
the entire installation process, but if
you prefer to reference a hard copy,
use this manual.
Visit: ring.com/app
Visit the online setup guide for
extra help
We also have an online guide with
videos and tutorials to help you set
up and use your Ring Video Doorbell.
Visit: ring.com/setup
Powering Your Ring
Charge your Ring Doorbell
before installation using the
supplied orange cable.
While charging, the circular
light on the front of your
Ring will let you know the
percentage it’s charged.
If you have an existing doorbell Ring
can run off its existing power supply
for a continuous charge (see step 6).
NOTE: Ring is not compatible with
most intercom systems.
If you DON’T have an existing
doorbell Ring can run off its built
in battery and last 6-12 months
between charges.
Step 2
Perform the in-app setup
The Ring app will walk you through
this process.
Download the Ring app by visiting
ring.com/app
Tap the plus sign in the Ring app to
set up a new device, and select Video
Doorbell when prompted.
Perform in-app setup near
your router. You’ll need your
network name and Wi-Fi password.
Step 3
Push the front button to test video
While inside near your router, push
the button on the front of your
doorbell to see live video in the Ring
app. Then, perform this same test
while outside.
If video quality is not as good
outdoors as it was indoors, you
may need to move your router closer
to your door or invest in a Wi-Fi
extender.
Learn more at: ring.com/extender
If your existing doorbell has
a diode, you’ll need to use
the diode included with your Ring
Doorbell for installation.
Step 4
Remove your existing
doorbell (optional)
If you’re replacing a wired doorbell,
first turn off the power at the breaker.
Then, remove your doorbell from the
wall, and disconnect the wires.
Diode
Step 5
Install the mounting bracket
Take everything that came in the
box (along with a power drill if
you’re installing on stucco, brick or
concrete), to the spot where you’re
installing your Ring Doorbell.
Snap the provided level onto the
mounting bracket, and align the
bracket accordingly.
Then, remove the orange tape, and
use the mounting bracket as a
template to mark four corner holes
for your screws.
Mounting
Bracket
On wood or siding, you can skip this
part and screw the bracket directly
onto your wall.
If you have one, it may help to
use a smaller drill bit to drill
pilot holes first.
Installing the mounting bracket
(continued)
On stucco, brick or concrete, install
the anchors using the provided drill
bit and a power drill before installing
the mounting bracket.
If you receive frequent motion
events, you may need to charge
your Ring more frequently.
MAC ID: XXXXXXXXXXX
S/N: XXXXXXXXXXX
Product name: Ring
FCC ID: YOPGS1011MEE
Model name: Video Doorbell
Power input: 8-24 VAC, 5Vdc 1 A
Getting Ready for Setup
Say “Hello” to the back of your Ring
Doorbell
Setup Button – You’ll be instructed to
push the orange setup button during
the in-app setup (see step 3).
While in setup mode, the light on the
front of your Ring Doorbell will spin.
Charging Port – Plug the orange
cable into the charging port to
charge your Ring Doorbell.
Setup Button Charging Port
2 3 4 5 6 7 8 9