Stick Up Cam Wired
1. Set up your Stick Up Cam Wired. Download the Ring app. The app walks you through setting up and managing your Stick Up Cam Wired. Search for “Ring” in one of the app stores below, or visit: ring.com/app Download from Windows Store Grab your Wi-Fi password. You’ll need it to set up your Stick Up Cam.
Let’s get your Stick Up Cam ready. How to power Stick Up Cam with USB: First, slide off the bottom cover. Two USB power supplies are included: One for indoor use, and one for outdoor use. Indoor Do not reattach this cover until setup is complete! Powering your Stick Up Cam You can power Stick Up Cam in one of two ways: Plug it into an outlet (with USB), or plug it into an Ethernet port that supplies Power over Ethernet (or PoE).
How to power Stick Up Cam with PoE: Set up your Stick Up Cam in the Ring app. In the Ring app, select Set Up a Device. Feed your Ethernet cable through the hole in the bottom cover and plug it into your Stick Up Cam. Then, plug the other end of the cable into an Ethernet port that supplies Power over Ethernet (or PoE). When prompted, select Security Cams and follow the in-app instructions.
2. Install your Stick Up Cam Wired. Choose a location. Stick Up Cam is happy just about anywhere, indoors or out. It comes ready to sit on a flat surface like a table or shelf, but can also be mounted to a wall or ceiling. Choose a spot where it can provide the view you want, within reach of a power outlet or an Ethernet port with PoE. How to use Stick Up Cam on a table or shelf: Make sure that any connected cables have been routed through the hole in the bottom cover.
How to install Stick Up Cam on a wall: Remove the plastic cover and rubber pad from the base. Push the rubber pad back into the base. You’ll put the cover back on once you’ve mounted your Stick Up Cam. The rubber pad should sit between your wall and the base of your Stick Up Cam. Flip the base to the rear. Drive the screws. The base of the stand is hinged. Before wall-mounting, flip the base down and behind your Stick Up Cam. Hold the round part of the base against your wall, rubberside down.
How to install Stick Up Cam on a ceiling: Remove the plastic cover from the base. You’ll put the cover back on once you’ve mounted your Stick Up Cam. Drive the screws. Hold the round part of the base against your ceiling, rubber-side down. Then mount it with the included screws. Rotate the stand above the camera: The whole stand can rotate on its axis. Before ceilingmounting, rotate the stand 180 degrees so the base is positioned above your Stick Up Cam.
Final steps for wall or ceiling mounting: Close it up. Make sure that any connected cables have been routed through the hole in the bottom cover. Then, slide the cover into place on your Stick Up Cam. Secure it with the attached screw, using the star-shaped end of the screwdriver bit. 14 Snap the cover back onto the base. Then, secure it with the included security screw, using the star-shaped end of the screwdriver bit. Now your Stick Up Cam is installed and ready to protect you.
For additional help, visit: ring.com/help Or give us a call… US 1 800 656 1918 Canada 1 855 300 7289 Worldwide +1 310 929 7085 For a list of all our customer support numbers, visit: ring.com/callus To review your warranty coverage, please visit www.ring.com/warranty. Patents: www.ring.com/patents © 2018 Ring LLC or its affiliates. RING, ALWAYS HOME, and all related logos are trademarks of Ring LLC or its affiliates.
