Instruction Manual

2
Ring Outdoor Contact Sensor
Introduction
The Ring Alarm Outdoor Contact Sensor is a wireless sensor for use with the Ring Alarm security
system. It provides users the ability to know when an outdoor window, door, gate or shed is open or
closed. After installing the sensor and setting it up in the Ring app, monitor and receive notifications
when the door or window opens or closes. The Ring Alarm Outdoor Contact Sensor requires a Ring
Alarm Base Station to enable features and functionality within the Ring app.
Ring Alarm Outdoor Contact Sensor – Basic Setup & Installation
1. Ensure your Ring Alarm system is disarmed.
2. In the Ring app, tap Set Up a Device > Security > Sensors to find the Outdoor Contact Sensor.
3. Follow the in-app instructions to complete setup.
a. Remove bracket and battery cover.
b. Pull the battery tab (or reinsert the batteries) to trigger setup mode.
c. Tap the orange setup button to retry setup mode.
Installation
1. Choose a door or window for installing your Outdoor Contact Sensor and companion magnet.
2. Ensure the surfaces where you plan to install your sensor and magnet are clean and free from
dust or dirt.
3. Using the provided double-sided tape, peel the backing and attach the sensor to the mounting
location. Screws and anchors are also provided for more permanent mounting. Metal strap ties
can be used but are not provided.
4. Follow the same steps for the companion magnet ensuring the magnet is aligned with the sensor
and no more than 1 inch from sensor for the “closed” position.
Note: Leave ~ ½ in. of space on the sensor side to ensure you can slide open the case when it’s time to
change the batteries.
Note:
• This product can be operated in any Z-Wave network with other Z-Wave certified devices from other
manufacturers. All mains operated nodes within the network will act as repeaters regardless of
vendor to increase reliability of the network.
• This is a Smart Start enabled product which can be added into a Z-Wave network by scanning the
Z-Wave QR Code present on the product with a controller providing Smart Start inclusion. No further
action is required and the Smart Start product will be added automatically within 10 minutes of being
switched on in the network vicinity. This product can also be operated in any Z-Wave network with
other Z-Wave certified devices from other manufacturers.