User Guide

1. Pre-Wiring
●
●
●
Prior to wiring, lay down the Ethernet cable from the mounting pole to the building power source.
Crimp the RJ 45 connector on Ethernet cable’s remote end (close to the building power source).
Follow the below process to make the RJ 45 connector at the Ethernet cable’s local end (close to the mounting pole)
with the waterproof gasket and cable gland provided in the base unit package.
●
●
●
Figure A: Remove the waterproof gasket from cable gland and packaging.
Figure B: Feed the Ethernet cable through the cable gland, sliding the gasket over the Ethernet cable.
Figure C: Slide the gasket back into the cable gland.
●
Connect the Ethernet cable’s remote RJ 45 connector to the PoE+ injector’s P-DATA OUT port.
Draft