User Guide

○
○
Don’t plug in the Ethernet cable’s local RJ 45 connector in the base unit port until all installation work is finished.
Don’t plug the PoE+ adapter connector into the building power source until all installation work is finished.
●
●
●
Figure D: Lay down the five (5) grounding wires between the mounting pole and the building grounding terminal.
Figure D: Crimp the five (5) grounding connectors on each of the grounding cables at the remote end (close to the
building grounding terminal).
Figure D: Connect the five (5) grounding cable remote end connectors on the building ground terminals.
2. Install Antenna
○
Figure E: Install the four (4) antennas on the antenna mounting bracket.
Draft