User Guide

○
○
○
○
Figure M: Disassemble the grounding screw from the bottom of the base unit.
Figure N: Crimp the connector on the grounding wire.
Figure N: Attach the connector to the grounding wire on the bottom of the base unit.
Figure P: Tighten the grounding screw.
●
●
●
●
Figure Q: Fix the base unit bracket on the mounting pole.
Figure R: Tighten the two pipe clamps.
Figure S: Fix the base unit into its mounting bracket, aligning the mounting holes.
Figure T: Insert screws into the four (4) mounting holes and tighten evenly with a T8 screwdriver (Tamperproof Torx).
Draft
4. Install the Base Unit