User Guide Outdoor Contact Sensor & a--.&,.1......
Quick Start ln-app Setup 1. Make sure your Ring Alarm is disarmed. 2. In the Ring app, open the menu. Tap Set Up a Device, then tap Security, tap Sensor, and find the Outdoor Contact Sensor. 3. Follow the in-app instructions to complete setup.
Installation We suggest mounting the Outdoor Contact Sensor using more than one mounting method, if needed. Make sure the Sensor and the Magnet are lined up, and 1" apart or less. Mounting Tape (included) Use the included mounting tape, clean the area, then peel the backing and stick the Sensor. Press it to the surface and hold for 20 seconds to make sure the tape is securely attached.
Metal strap tie (not included) Feed the metal strap tie through the back of the sensor and magnet brackets. Make sure that you tighten the strap tie so it doesn't slide around or down the pole. If it does move around, consider also using screws to keep it in place. Slide the Sensor and Magnet onto the mounting brackets when you've finished mounting them. \ 1 in 2.54 cm max CJ) C ·L.
0) C ·L ' fl 0.5 in 1.
D • • • For additional help, visit: ring.com/help Find online manuals at: ring.com/alarm-manual For technical Z-Wave information, visit: ring.com/z-wave © 2021 Ring LLC or its affiliates. Ring and all related marks are trademarks of Ring LLC or its affiliates.
Important Product Information Renseignements lmportants Relatifs au Produit
ENGLISH SAFETY INFORMATION FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE. WARNING : Your device should only be used in accordance with the specific instructions for use and intended purpose of the device. Using your device in any way other than its intended purpose could cause injury to yourself, others and/or damage to the device or property. WATCH FOR SMALL PARTS! Your device and accessories may present a choking hazard to small children.
CAUTION : Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of the used batteries according to the manufacturer's instructions. Maintaining Your Ring Outdoor Contact Sensor Use only accessories supplied with your device, or specifically marketed for use with your device, to power your device.
FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to part 15 of the FCC Rules.
contact during normal operation. This device should be installed and operated with at least 20 cm between the radiator and your body. FOR CONSUMERS IN CANADA Innovation, Science and Economic Development Canada (ISED) Compliance IC ID: 10256A-SF49E9 This device contains licence-exempt transmitter(s)/ receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 1. This device may not cause interference. 2.
Ring LLC 1523 26th St. Santa Monica, CA 90404 USA 0 2021 Ring LLC or ,ts affiliates.Ring and all related marks are trademarks of Ring LLC or its affiliates. For Z-Wave technical information, visit ring.com/ z-wave. Pour des informations techniques sur 2-Wave, visitez ring .
