User Guide Glass Break Sensor
ln-app Setup 1. Make sure your Ring Alarm is disarmed. 2. In the Ring app, open the menu. Tap Set Up a Device, then tap Security, tap Sensor, and find the Glass Break Sensor. 3. Follow the in-app instructions to complete setup.
Installation We suggest mounting the Glass Break Sensor at least 7' (2m) off the ground, and close to your glass windows and doors. Wall. Use the included mounting tape, clean the area, then peel the backing and stick the Sensor. Press it to the wall and hold for 20 seconds to make sure the tape is securely attached. Ceiling. Use the included screws and anchors. First remove the back cover and set the Sensor aside. Screw the back cover to the ceiling.
Microphone - ...
0 0
For additional help, visit ring.com/help To download this manual, visit ring.com/alarm-manual For technical Z-Wave information, visit ring.com/z-wave Ring LLC 1523 26th St. Santa Monica, CA 90404 © 2021 Ring LLC or its affiliates. Ring and all related marks ·are trademarks of Ring LLC or its affilrates.
Important Product Information Renseignements lmportants Relatifs au Produit
•U@•HH IMPORTANT PRODUCT INFORMATION Ft\. l.lJ SAFETY INFORMATION FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE. WARNING: Your device should only be used in accordance with the specific instructions for use and intended purpose of the device. Using your device in any way other than its intended purpose could cause injury to yourself, others and/ or damage to the device or property.
RECYCLING YOUR DEVICE PROPERLY In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with your local laws and regulations. For information about recycling your device, go to amazon.com/devicesupport. Terms of Service and Warranty By purchasing or using the product, you agree to the Terms of Service found at ring .com/ terms. For information on our warranty visit ring.com/ legal.
Information Regarding Exposure to Radio Frequency Energy The output power of the radio technology used in the Products is below the radio frequency exposure limits set by the FCC. Nevertheless, it is advised to use this product in such a manner that minimizes the potential for human contact during normal operation. This device should be installed and operated with at least 20 cm between the radiator and your body.
Cet appareil contient des emetteurs/recepteurs exempts de licence qui sont conformes aux normes CNR d'lnnovation, Sciences et Developpement economique Canada. Son utilisation est soumise aux deux conditions ci-dessous. 1. Cet appareil ne doit pas causer d'interferences. 2. Cet appareil doit accepter toute interference, y compris les interferences pouvant causer un fonctionnement indesirable de l'appareil.
Ring Glass Break Sensor Z-Wave Dev1 lca Specific Kay (OSK) Z--Wave DiSK: 07300-28022-35474-51372-00537-38107-60711-03651
