User's Manual

Hereby, Bot Home Automation, declares that this consumer electronic is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC. The declaration of conformity may be consulted
at www.ring.com/DoC.pdf.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Use this device in dry rooms only. Do not cover the device while operating. Do not open the housing. Protect this
the device if the plug or housing is defective, there is a risk of electric shock.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20 cm between the radiator & your body.
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or transmitter.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not
possible.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions:(1)This device may not cause interference; and (2)This device must accept any interference, including
interference that may cause undesired operation of the device.
Allow fixture to cool before handling.
Do not cut any wires with factory installed wire connectors or remove the wire connectors.
Do not install on circuits feeding motor loads such as kitchen appliances, HVAC equipment, washer/ dryer or garage
door openers.
Do not install when it is raining
Do not stare directly at the LEDs for more than a few seconds to avoid eye injury.
Do we need to include all the electrical qualifications this light meets? Tech Specifications, Guarantee
FIRE RISK: Do not mount near combustible or flamable surfaces.
Floodlight Cam does not serviceable parts or replaceable LEDs
Floodlight Cam should be installed outdoors to a wall or eaves, not the ground.
Instructions do not cover everything
1523 26th St.
Santa Monica, CA 90404