Installation Instructions

ManualsBrandsRing ManualsElectrical EquipmentFloodlight Cam Wired Plus

[FRONT COVER]

Title:

Ring Floodlight Cam

Model name: 5AT3T2

[MANUAL]

Warnings:

[electric shock image] WARNING: Risk of electrical shock.

Disconnect power at the fuse or circuit breaker before installing.

Verify that the supply voltage is correct. Connect fixture to a 100 VAC~240 VAC 50/60 Hz

power source.

Properly ground fixture.

Always follow code standards when installing wired connections.

CAUTION: Risk of fire. Do not install near combustible or flammable surfaces.

NOTICE: Do not connect this light fixture to a dimmer switch or timer.

Your Floodlight Cam must be installed on a 4” round UL listed weatherproof electrical box.

This manual is for informational purposes only. Working with electricity can be dangerous

unless proper safety precautions are taken. If you are not comfortable or are inexperienced with

the processes and tools described in this manual, we recommend that you hire a licensed

electrician.

Hardware:

Bag A:

(2) Standard Mounting Screws: These should fit most junction boxes

Bag B:

(3) Long Mounting Screws: For screw holes in recessed junction boxes

Bag C:

(3) Long Mounting Screws: For screw holes in recessed junction boxes

Bag D:

(2) Thin Mounting Screws: To fit older boxes with smaller screw holes

Summary of content (5 pages)

PAGE 1
[FRONT COVER] Title: Ring Floodlight Cam Model name: 5AT3T2 [MANUAL] Warnings: [electric shock image] WARNING: Risk of electrical shock. Disconnect power at the fuse or circuit breaker before installing. Verify that the supply voltage is correct. Connect fixture to a 100 VAC~240 VAC 50/60 Hz power source. Properly ground fixture. Always follow code standards when installing wired connections. CAUTION: Risk of fire. Do not install near combustible or flammable surfaces.
PAGE 2
Bag E: (2) Thin Mounting Screws: To fit older boxes with smaller screw holes Bag F: (2) Thin Mounting Screws: For older boxes with smaller screw holes Bag G: (3) Hex Cap Nuts: To secure your Floodlight Cam Header: Shut off power at the breaker! Body: You’ll be working with electrical wires during the install process. If you don’t know where your breaker is or how to turn off power to your floodlight circuit, we recommend you hire a licensed electrician.
PAGE 3
Header: Choose your screws. Body: Select a set of screws from the bags marked “A” through “E” that fit your junction box to secure the metal mounting bracket. One size does not fit all here, so we sent several. Table: Bag A Bags B & C Bags D, E, & F Standard screws. These should fit most junction boxes. Longer screws to reach the screw holes in recessed junction boxes. Best for older boxes with smaller screw holes. Header: Attach the metal mounting bracket.
PAGE 4
Image: Placing buckle onto hook. Header: Connect the wires. Body: The green wire on your Floodlight Cam is the ground wire. With power still off at the breaker, use a wire nut from the bag marked “G” to connect the green (or ground) wire from your Floodlight to the green wire coming from your junction box. The white wire on your Floodlight Cam is a neutral wire.
PAGE 5
Restore power at the breaker. Body: Now that your Floodlight Cam is installed, you can turn power back on at the breaker. The lamps on your Floodlight Cam will flash/The light on the front of your Floodlight Cam will blink once it’s powered on. Header: Complete setup in the Ring App. Body: Once your Floodlight Cam powers on, follow the instructions to continue with setup in the app. [BACK COVER] Body: For additional help, visit: ring.