User's Manual

Install anchors (optional)
If installing on stucco, brick, or concrete,
mark 4 drill holes. Use the provided bit
to drill holes in your wall and insert the
anchors.
If you’re installing
on wood or siding,
skip this step and
toss the anchors in
that drawer of stuff
you never use.
Install the diode (optional)
If you’re wiring your Ring Doorbell to a
digital doorbell – you’ll know it’s digital
if it plays a melody – then install the
included diode.
If your existing doorbell is mechanical, DO
NOT use the diode, as it can damage your
existing doorbell.
Not sure? Visit ring.com/diode
The lighter band on
your diode should be
on the same side as
the wire that runs to
the “Front” terminal on
your internal doorbell.
If you don’t know
which side this is, don’t
worry, since wiring the
diode the wrong way
can’t do any harm.
If your internal
doorbell doesn’t ring
when pushing the
button on your Ring
Doorbell, just reverse
the wires on the back
of your Ring Doorbell
and try again.
1514
1. In-app Setup 2. Physical Installation 3. Features 4. Troubleshooting
1. In-app Setup2. Physical Installation3. Features4. Troubleshooting
Steps for wiring to an existing doorbell