Users Manual
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
For best results, use type Li-Ion batteries. Install only new batteries of the same type
in your product. Failure to insert batteries in the correct polarity, as indicated in the
battery compartment, may shorten the life of the batteries or cause batteries to leak.
Do not mix old and new batteries. Do not mix Alkaline, Standard (Carbon-Zinc) or
Rechargeable (Nickel Cadmium) or (Nickel Metal Hydride) batteries. Do not dispose
of batteries in fire. Batteries should be recycled or disposed of as per state and local
guidelines.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Hereby, Bot Home Automation, declares that this consumer electronic is in
compliance with the essential requirements and other relevant provisions of
Directive 1999/5/EC. The declaration of conformity may be consulted at
www.ring.com/
DoC.pdf.
Protect the device from direct sunlight. Install the device at dry locations and
protect it against rain and humidity. The device may not get contact to salt
water or other conductive liquids. The device must be charged only within a
building in a dry state.
© 2016 Bot Home Automation, Inc.
RING, ALWAYS HOME, and CHIME are trademarks of Bot Home Automation, Inc.
Ring Video Doorbell is patent pending.