Safety Instructions

Model: Ring Smart Lightbulb (PAR38)
IMPORTANT PRODUCT INFORMATION
Safety and Compliance Information
Use Responsibly. Read all instructions and safety information before use.
SAFETY INFORMATION
FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER
INJURY OR DAMAGE.
Small parts may pose choking hazards. Keep device and box contents out of reach of children.
Turn off power before inspection, installation, or removal. Ensure that voltage of the bulb is compatible with the mains
electricity of your country before connecting to a bulb holder. Do not force bulb base into incompatible bulb holder.
Not intended for use in emergency light fixtures or exit signs.
Your bulb can withstand outdoor use and has been tested to withstand water projected through a 5.0mm nozzle at a
volume of 12.5 liters per minute and a pressure of 34.5 kPa at a distance of 1.4 meters for at least 3 minutes. However,
your bulb is not intended for underwater use. To protect against electric shock, do not intentionally submerge or
immerse your bulb in water or expose your bulb to other liquids. Do not spill any food or beverages on your bulb. Do
not attempt to clean or polish your bulb with or expose your device to oil, lotion, or other abrasive substances. Do not
expose your bulb to pressurized water, high velocity water, or extremely humid conditions (such as a steam room).
Do not attempt to dry your bulb with an external heat source, such as a microwave oven or a hair dryer. If your bulb
appears to be damaged, discontinue use immediately.
WARNING: Risk of Electric Shock. Do not attempt to open or disassemble the bulb. Do not use where directly
exposed to water.
Not suitable for use with standard wall dimmers. This device is not intended for use with emergency exit fixtures
or emergency lights. Switch off the power supply to the socket and allow sufficient time for the bulb to cool before
removing the bulb from fitting. Use the bulb only in a socket rated for this bulb. Dispose of this device in accordance
with disposal laws in your area. Not compatible with photo sensors, motion sensors or timers unless specifically
designed for Ring Smart Lighting.
Product Specifications
Model Number: 5AT1S4
Electrical rating: 120VAC, 150mA, 16W, 60Hz
Operating conditions: -4˚F to 104˚F (-20˚C to 40˚C)
Recycling Your Device Properly
In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device
in accordance with your local laws and regulations. For information about recycling your device, go to www.amazon.
com/devicesupport.
For Canadian Customers
Innovation, Science and Economic Development Canada (ISED)
Innovation, Science and Economic Development Canada (ISED) Compliance. This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Conformité Innovation Sciences et Développement Économique Canada (ISDE)
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre
le fonctionnement.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your
authority to operate this equipment.
Information Regarding Exposure to Radio Frequency Energy:
This equipment complies with IC RSS-102 RF exposure limits set forth for an uncontrolled environment.
Renseignements relatifs à l’exposition à l’énergie des radiofréquences:
Cet équipement est conforme aux limites d’exposition IC CNR-102 prévues pour des environnements non contrôlés.
This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body.
Cet équipement doit être installé et utilisé avec un minimum de 20 cm de distance entre la source de rayonnement
et votre corps.
CAN ICES-3 (B)/NMB-3(B)
1523 26th St.
Santa Monica, CA 90404
Ring_Smart_Lights_legal_Wave2_par38_Bulbs_content.indd 1 12/3/19 1:39 PM