Safety Instructions

Table Of Contents

Quick Start

1. Set up and install your Ring Bridge.

2. Open the Ring app.

Then, tap Set Up a Device and follow the in-app instructions.

3. Scan this code.

This identifies your Ring Mailbox Sensor for fast and easy setup.

For additional help, visit:

ring.com/help

Let’s get started.

SAFETY INFORMATION

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS COULD RESULT IN FIRE, ELECTRIC SHOCK, OR OTHER INJURY OR DAMAGE.

BATTERY SAFETY

This product contains alkaline batteries. This device requires batteries for use. Only use new 1.5V alkaline or 1.2 NiMH rechargeable AAA-sized

batteries. Never mix old and new batteries. Keep all of the batteries out of the reach of children. Do not open, disassemble, puncture, cut,

bend, shred or heat the batteries and do not allow metal objects to touch the battery terminals on the remote as they can become hot and

cause burns. Remove all batteries if they are worn out or before storing your Device for an extended period of time. Dispose of all batteries in

accordance with applicable laws and regulations and do not dispose of batteries by throwing them into a ﬁre. If any batteries begin to leak,

take steps to prevent the ﬂuid from coming into direct contact with skin or clothes as the ﬂuid could be corrosive and may be toxic. Remove

the batteries and clean the battery compartment in accordance with the battery manufacturer’s recommendations.

PRODUCT SPECIFICATIONS

Model Number: Ring Mailbox Sensor

Electrical Rating: 3 x AAA-cell batteries

Temperature Rating: -4°F to 122°F (-20°C to 50°C)

RECYCLING YOUR DEVICE PROPERLY

In some areas, the disposal of certain electronic devices is regulated. Make sure you dispose of, or recycle, your device in accordance with

your local laws and regulations.

FCC Compliance: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The party responsible for FCC compliance is: Ring LLC, 1523 26th St, Santa Monica, CA USA, 90404

By purchasing or using the product, you agree to the Terms of Service found at ring.com/terms.

For information on our warranty, theft protection, and Ring Protect Plans, see ring.com/legal.

IMPORTANT PRODUCT INFORMATION

Safety and Compliance Information

Use Responsibly. Read all instructions and safety information before use.

marks are trademarks of Ring LLC or its aliates.

QR+FR

L SHAPE CARD 350G C2S

114

131

PAGE 1
14 Let’s get started. IMPORTANT PRODUCT INFORMATION 131 Safety and Compliance Information Use Responsibly. Read all instructions and safety information before use. Quick Start 1. Set up and install your Ring Bridge. 2. Open the Ring app. Then, tap Set Up a Device and follow the in-app instructions. 3. Scan this code. This identifies your Ring Mailbox Sensor for fast and easy setup.
PAGE 2
IMPORTANT PRODUCT INFORMATION FOR UNITES STATES CUSTOMERS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Information on this device is on file with the FCC and can be found by inputting the device’s FCC ID into the FCC ID Search form available at https://www.fcc.gov/oet/ea/fccid.