User's Manual

Wireless Bluetooth receiver function

User’s manual

The Symphony Grand is able to work with computer devices using Bluetooth protocol.

This will allow you to play audio on your computer or tablet device into the Symphony

Grand’s sound system. You can also use Bluetooth to send MIDI data bi-directionally

between the computer or tablet as well. It is recommended not to use Audio and MIDI

simultaneously because this may cause some latency with the MIDI functions.

You can also send MIDI messages to and from the Symphony Grand to your computer

or tablet device.

Installation

1. Make sure that the digital piano is powered off, then connect the J4 of CSR8670

board to main board, connect the J3 of CRS8670 board to power board, connect the

J1 of CSR8670 board to the light board.

2. make sure that all connection are correct and all boards are normal performance,

and turn on the digital piano, the bluetooth is power on at same time, the bluetooth

enters into the pairing mode.

Audio Functions

Pairing- In order for Bluetooth to work you must pair two devices. This will allow

them to communicate with each other. Make sure that the Bluetooth LED is lighted

on the front panel to indicate that the Bluetooth mode is on. If it is the Symphony

Grand should be discoverable on your device. If the LED is not on then you should

go into the function mode to enable Bluetooth. See the section for how to turn on

Bluetooth below.

On your computer or tablet you need to enable the Bluetooth mode. Once you have

enabled Bluetooth you can select the Symphony Grand as a device. It should show

up on your computer or tablet as "Symphony Grand".

Once you have selected the Symphony Grand you can now play audio from the computer

or tablet device to the Symphony Grand. Audio can only be sent from the computer

or tablet to the Symphony Grand. You cannot send audio from the piano to your

computer.

Bluetooth MIDI

In order to send and receive MIDI messages with the Symphony Grand you need to

have an application on your computer or tablet that has MIDI Bluetooth functionality.

As long as the Bluetooth Mode is on it should be discoverable on your computer or

tablet to set up pairing and communication.

Turning Bluetooth Mode on and off.

Bluetooth should be turned on with the Symphony Grand. If you find that the

Bluetooth ID is not shown on your computer or tablet, check to make sure that

Bluetooth is turned on. The LED on the front panel should be lit.

Bluetooth is enabled using Function mode:

1. Press Function

2. Press Main page

3. Bluetooth should be set to on.

PAGE 1
Wireless Bluetooth receiver function User’s manual The Symphony Grand is able to work with computer devices using Bluetooth protocol. This will allow you to play audio on your computer or tablet device into the Symphony Grand’s sound system. You can also use Bluetooth to send MIDI data bi-directionally between the computer or tablet as well. It is recommended not to use Audio and MIDI simultaneously because this may cause some latency with the MIDI functions.
PAGE 2
After your computer or tablet device has paired the Symphony Grand you should be able to send Audio or MIDI to the keyboard. If you have already paired the Symphony Grand with a Bluetooth device, you will need to unpair it from that device before trying to pair with another device. FCC Caution. § 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules.