Infinity 24e Continuous Flow Water Heater User's Manual

TEMPERATURE CONTROLS - INSTALLATION

Universal Temperature Controller

MC-91-1A

1. Determine the most suitable position for the

temperature controller.

2. Drill 3 holes in the wall as shown in fig. 1, one

for the cable and two for the securing screws.

Ensure holes are drilled deep enough. Fit wall

plugs if needed. (ensure controller is level.)

3. Run the cable provided through the hole in the

wall ensuring that the end fitted with the

connector is nearest the controller. (fig. 2.)

4. Remove the face plate from the controller using

a flat screwdriver. Take care not to damage the

cover (fig. 3.)

5. Connect the cable to the temperature controller.

6. Fix the controller to the wall and fasten with the

phillips head screws supplied as shown in (fig.

4.)

7. Remove the protective plastic film from the

controller face as shown in fig. 4.

8. Replace the face plate.

NOTE