Installation manual
1-21/32”
3-5/16”
Remote Cont ro ll ers Installation to Appliance
For models : V2520FFU/FFUC and V2532FFU/FFUC
DO NOT ATTEMPT TO CONNECT THE REMOTE CONTROLLERS
WITH THE POWER ON, THERE'S 120 VOLT POTENTIAL, NEXT TO
THE REMOTE CONTROLLER CONNECTIONS INSIDE THE UNIT.
All service and wiring should be performed by a certied installer.
43
Rinnai America
FF Models
I N S TA L L E R ’ S I N S TA L L AT I O N I N S T R U C T I O N S
Remote Controllers - Installation
1) Determine a suitable location for the controller.
2) Make three holes on the wall as shown.
3) Run the cable between the controller and the Rinnai
Water Heater or the controller and the other controller.
4) Remove the face plate from the remote controller(s).
5) Connect the cable to the remote controller(s).
6)
Mount the controller to the wall using the holes drilled in step 2.
7) Disconnect the power from the Rinnai Water Heater.
8) Remove the cover of the Rinnai Water Heater.
9) Remove the plastic cover from the PCB and electrical connections.
10) Thread the cable through the access hole at
the base of the unit and connect the wires
to the controller terminals.
11) Secure the controller cable using the clamp
provided.
12) Replace plastic cover over PCB and then
replace the cover of the Rinnai Water
Heaters.