AvengerPlus Natural Gas Heater
Table Of Contents
- RINNAI GUARANTEE OF QUALITY
- ABOUT YOUR NEW AVENGER/CAPELLA TRE
- CONTROL PANEL LAYOUT
- REMOTE CONTROL
- FEATURES
- IMPORTANT POINTS
- ADJUSTING TEMPERATURES
- HEATER MODES & FUNCTIONS
- SETTING HEATER MODES
- SETTING CLOCK
- PROGRAMMING THE ON/OFF TIMERS
- OPERATING THE ON/OFF TIMERS
- PRE-HEAT
- OVERIDE FUNCTION
- USING THE REMOTE CONTROL
- CHILD LOCK
- SAFETY DEVICES
- CARE OF HEATER
- FAULT FINDING
- ERROR CODES
- SPECIFICATIONS
- CUSTOMER CONTACTS
Rinnai Australia20 RCE-470/670 TRE
Your heater needs very little maintenance, but the following information will help you to keep it looking good, and
working efficiently.
Unplug before cleaning.
All parts of the heater can be cleaned using a soft, damp cloth.
Do not use solvents to clean any parts.
Do not spray aerosols in the vicinity of the heater whilst in operation.
Do not place articles on or against this heater.
Do not store flammable materials near this heater.
AIR FILTERS
Dusty filters reduce the air flow through the heater as well as reducing the heater's effectiveness.
Do not wait for filter warning lamp to come on before cleaning filters.
Do not use the heater with the filter warning lamp on, this may cause it to overheat.
REMOVING FILTERS
Filters require cleaning at least
once a week during the heating
season to prevent unnecessary
cut-out due to a build up of dust
particles.
For cleaning Filters 1 & 2, undo
and remove the retaining screw
(ensuring to store the retaining
screw in a safe place)
Carefully lift filters up then
backwards to remove from
locating tabs.
With the careful use of a vacuum
cleaner, gently remove any
contaminates such as dust and
lint.
Replace filters by carefully repositioning the location tabs and fasten in place with the retaining screw.
Filter 3 (the small filter) should be left in position for cleaning, carefully use a vacuum cleaner to remove any
contaminates such as dust and lint.
CARE OF HEATER