Remote Manual

IT IS THE CUSTOMERS RESPONSIBILITY TO MONITOR THE BATH FILL
REMOTE CONTROLLER FUNCTIONS.
Be careful not to overfi ll the bath, an average bath volume is 60 gallons. It is
recommended that when fi lling a bath for the fi rst time you should:
=
Remain by the bath during the fi lling process.
=
Use a low bath fi ll volume such as 25 gallons or less.
‘Water Smart / Bath Fill’ button is unavailable with the MSA Controller System.
16
Rinnai America
FF Models
DELUXE BATHROOM CONTROLLER
OPERATING THE WATER SMART / BATH FILL BUTTON
The ‘Water Smart / Bath Fill’ button allows a preset water volume and
temperature to be selected and run automatically.
Initial Settings
When you press the ‘Water Smart / Bath Fill
’ button, a Shower /
Bath Volume will appear on the indicator. When a deluxe bathroom
controller(s) is fi rst turned on, the default shower / bath fi ll volume
is set to 25 gallons. The shower / bath volume can be lowered to a
minimum of 10 gallons or raised to a maximum of 120 gallons.
Programming shower / Bath Volume and Temperature
With the system on, select a Deluxe Bathroom controller(s) and ensure that it currently has
priority, If it does not have priority, press the ‘Priority’ button once and the ‘Priority’ button will
To select the desired delivery temperature, use the
‘Temp.’
or buttons.
The selected temperature will be displayed on the
bathroom controller monitor and will remain as the
default temperature until it is changed.
To select the volume of water to be used by the
shower / bath, use the ‘Water Vol.’
or
buttons.
The selected volume is displayed at the Right of
the controller monitor numerically.
When fi lling a bath for the fi rst time, it is
recommended that a low bath fi ll volume such as
25 gallons or lower (if available) be used. During
any subsequent bath fi lls, the volume can then be
adjusted to suit your known bath volume and / or
desired fi ll level.