Installation manual

18
TWIN FLOW ELECTRICS
All of the mains electrics has been prewired. The only mains voltage electrical
installation that needs to be done is to plug the Twin Flow in. This has been done so
that the installer does not require any special certification such as Part P, and to
make it as easy as possible. The side of the unit has two isolator switches that
isolate the appliances on both poles with at least a 3mm gap. If the installer chooses
to cut off the moulded plug and wire into a permanent supply this will not effect the
warranty as long as it is done correctly.
Both the water heater and boiler have to be connected into the loom, via the
appropriate plugs as show on the following pages
Backplate connection box
Moulded
Plug
Water Heater Boiler