Installation manual

Rinnai New Zealand 4 Operation Manual:01-07
DELUXE WATER CONTROLLERS
ABOUT THE DELUXE BATHROOM WATER CONTROLLER (BC-100V)
HOW TO USE THE DELUXE BATHROOM Water CONTROLLER (BC-100V)
Turning on the Controller
If the controller is switched off (No digits other than the
clock digits displayed in the digital monitor) press the
On/Off button once.
The On/Off and Transfer buttons illuminate to indicate
that the hot water unit will be ready to supply hot water
once a hot water tap is opened.
If more than one controller is fitted press the ‘Transfer’
button to transfer priority to the desired controller.
Refer to page 1 to confirm the maximum number and combination of water
controllers that can be fitted to your Water Heater model.
Avoid getting water directly in the speaker as this may cause damage.
Used to transfer control priority between
the temperature controllers. The
controller with priority has command of
the hot water delivery temperature. This
button is illuminated when this controller
has priority.
TRANSFER BUTTON
SPEAKER
Indicates that the water heater is in
operation and delivering hot water.
WATER HEATER
'In Use' INDICATOR
Indicates the selected hot water
temperature.
WATER TEMPERATURE
INDICATOR
Indicates that the Shower Saver / Bath
Fill function has been selected and that
a shower is running or the bath is filling.
SHOWER SAVER /
BATH FILL INDICATOR
12 Hour AM / PM clock display.
Indicates how much water still needs to
flow for the selected Shower Saver /
Bath Fill volume, decreasing while
shower runs or bath fills.
In the event of a fault, error message
codes will flash here.
CLOCK & REMAINING WATER
VOLUME INDICATOR
In Normal and Bath Fill / Shower Saver
modes these buttons are used to select
the water temperature.
In 'Clock' mode these button are used to
set the clock.
TEMPERATURE BUTTONS
Indicates Shower Saver / Bath Fill
volume selected.
WATER VOLUME INDICATOR
Used to select Shower Saver / Bath Fill
volumes.
WATER VOLUME BUTTONS
Used to select the voice and audible tone
options.
SOUND VOLUME BUTTON
Used to select Shower Saver / Bath Fill
function. This button is illuminated when
the Shower Saver / Bath Fill function is
selected.
Used select clock setting mode.
CLOCK SETTING BUTTON
SHOWER SAVER
/ BATH FILL BUTTON
Used to switch the water heater on and
off. This button is illuminated when the
hot water heating system is on.
ON/OFF BUTTON
DIGITAL
MONITOR
NOTE