Use and Care Manual
18 Fan Convector Manual
OperangTheHeater
TURNINGON:
Press the ON/OFFbuon to operate the heater. The
ON indicator will glow green. Aer approximately 3
seconds the spark generator will be heard before the
burner ignites and the ON indicator glows red,
indicang that the burner is lit. Warm air can be felt
coming from the louvers approximately 5 seconds
later.
NOTE
If the heater does not ignite on inial try, air may be
remaining in the gas supply line. The spark generator
will only connue for 15 seconds. Aer this, it will be
necessary to press the ON/OFF buon OFF, then ON
again.
TURNINGOFF:
Simply press the ON/OFFbuon to switch off the
heater. The ON indicator will go out. The convecon
fan will connue to operate for several minutes aer
the burner has gone out in order to cool the
appliance. Donotunplugtheappliancewhilethe
conveconfanisrunning.
NOTE
DO NOT turn heater off by unplugging. The
convecon fan will connue to run as the appliance
needs to cool.
RoomTemperatureAdjustment:
NOTE
The room temperature and pre‐set temperatures can
only be displayed and adjusted when the heater is
running.
Press the " " buon to increase the temperature
seng or " " buon to decrease the tem‐
perature seng.
The temperatures can be set to:
a) [L] low (minimum combuson)
b) [60°F] to [80°F] in 2°F increments
c) [H] high (maximum combuson)
(Default temperature seng is 72°F)
NOTE
If the heater does not ignite, then the pre‐set
temperature may not be set to a seng that is
higher than the actual room temperature.
AUTOOFF:
When AUTOOFFis selected, the indicator light will
glow. The unit will now be under full thermostat
control. The heater will operate to reach the
selected room temperature and then turn OFF.Press
AUTO OFF again to disable this funcon.
NOTE
When AUTO OFF indicator light is not glowing , the
unit will connue to produce heat in at least a low fire
capacity unl the unit is manually powered down.