Use and Care Manual

26 Fan Convector Manual
1. Confirm that the heater is properly installed. See Installaon secon.
2. Make sure the gas valve on the propane gas bole or gas supply line is ON and that gas pressure is available.
3. Make a careful visual inspecon of all electrical connecon and wiring.
4. If trouble persists, refer to the following trouble shoong chart and corresponding remedy.
Troubleshoong:
Problem
Cause
No On indicator
Burner does not ignite
Filter warning lamp glows
Combuson stops during operaon
Takes too long to warm the room
Remedy
Not Plugged In
Plug in
Power Failure
Manually operate (push ON/OFF
Buon) aer power is restored.
(Inial Installaon)
Air in gas pipe
Purge air (Installer)
Room too large Check with retailer
Dust on the air filters Clean air filters (WEEKLY)
Louvre obstructed Clean obstrucon
Air filter blocked Clean filter (WEEKLY)
On/Off Timer is set Cancel On/Off Timer
Child Proof Lock set Cancel Child Proof Lock
Gas turned off at meter Turn gas on (SERVICER)