Specifications

18 Fan Convector Manual
Seng the Clock: (FC824)
When the appliance is rst plugged in and then
turned on, the digital display will show “- -:- -”
Aer 10 seconds the Digital Display will turn o.
Example: seng the clock to 10:35 A.M.
1. Press the Set Time Buon once, the Clock
Indicator will glow.
2. Press and hold the " " buon; the minutes will
begin to change rst, then the me will change by
whole hours. Release the buon when AM 10:00
shows on the Digital Display. Conrm that you have
selected AM. A small indicaon on the le hand side
of the Digital Display should indicate the AM seng.
Then press and hold the " " buon again, release
the buon when AM 10:35 shows. If you go past AM
10:35, then the " " buon can be used to change
the me sengs in reverse.
3. Press the Set me buon ve mes to lock in the
me. The Clock and Timer indicators will go out. Aer
10 seconds the Digital Display will turn o.
Programming the On/O Timer(s) (FC824)
NOTE
Before programming the Timer(s), ensure the clock
me has been set.
Example: seng Timer 1 to heat between 7:10 A.M to
9:00 A.M.
1. Press the Set Time Buon twice. The digital
display will show AM 6:00. Timer 1 Indicator will glow.
2. Press the " " buon unl AM 7:00 appears.
Release the buon, then press it again unl AM 7:10
appears. (Press the " " buon if you go past AM
7:10.)
3. Press the Set Time buon again, the Timer 1 OFF
indicator will glow. Press the " " buon unl AM
9:00 appears.
4. Press the Set Time buon three mes to lock in
the programmed me. The digital display will show
the current me. Aer 10 seconds the digital display
will turn o.
NOTE
Timer 2 is programmed in the same way simply
choosing Timer 2 instead of Timer 1. Timers can be
programmed to operate for any 2 periods within 24
hours. The programmed me must be selected and
locked in within 1 minute of the Timer Indicators
glowing, otherwise the adjustment will not be saved .