Specifications

Fan Convector Manual 19
Operang the Timer(s) (FC824):
NOTE
Before operang the Timer(s), the clock me must be
correct, and a starng me and nishing me for the
Timer(s) must be programmed. The two Timers
operate in the same way. This heater will begin
operang before the programmed starng me in
order for the room to reach the temperature seng
by the programmed starng me.
1. To select the Timer(s) to commence heang:
Check that the me shown on the Digital Display is
correct. Check the ON and OFF mes for both Timers.
2. Press the ON-OFF buon to operate the heater:
The On indicator will glow green and the heater will
begin to operate. Select the desired temperature
seng.
3. Press the Timer 1 and On Timer 2 buon(s). The
Timer indicator(s) will glow and the heater will remain
on standby unl one hour prior to the me
programmed into the selected Timer(s). When this
me is reached, the Timer indicator will ash and the
heater will operate. The ON indicator glows red when
the heater commences operaon.
The heater can be operated to alternate between
Timers automacally during cold weather by selecng
Timer 1 and Timer 2 together. Both Timer indicators
will glow. The appliance will remain on standby at
intervals between the programmed nishing and
starng mes of each Timer. While the heater is
operang during programmed intervals the Timer
indicator will ash.
NOTE
If there is a power failure, the system memory will
retain the Timer programs and the clock will stop at
when the power goes o. The clock will start keeping
me again when the power returns but will have to be
reset to the correct me.
Override Funcon:
NOTE
This funcon is intended to be used to manually
override the current operaon of the heater while it is
in Timer mode. For example, if the heater is in standby
(between the end me and start me of the Timer),
and the Override buon is pressed, then the heater
will operate and heat the room. If the heater is in
operaon in Timer mode, then pressing the Override
buon will turn the heater OFF.
To operate the Override simply press the Override
buon. The Override indicator will ash.
To manually deacvate the Override simply press the
Override buon again. The Override indicator will go
out, and the heater will return to standby mode or
ON mode depending on the programmed mes.
NOTE
The heater will connue to operate on Override unl
the Override buon is pressed again, or one of the
Timers takes over the operaon of the appliance. This
means that the Override mode will automacally
drop out if a programmed Starng me is reached.
The appliance will then return to operang at mes
programmed into the Timer(s).