Specifications

Fan Convector Manual 23
1. Conrm that the heater is properly installed. See Installaon secon.
2. Make sure the gas valve on the LP gas bole or gas supply line is ON and that gas pressure is available.
3. Make a careful visual inspecon of all electrical connecon and wiring.
4. If trouble persists, refer to the following trouble shoong chart and corresponding remedy.
Troubleshoong:
Problem
Cause
No On indicator
Burner does not ignite
Filter warning lamp glows
Combuson stops during operaon
Takes too long to warm the room
Remedy
Not Plugged In
Plug in
Power Failure
Re-ignite manually aer
power is restored
(Inial Installaon)
Air in gas pipe
Purge air (Installer)
Room too large Check with retailer
Dust on the air lters Clean air lters (WEEKLY)
Louvre obstructed Clean obstrucon
Air lter blocked Clean lter (WEEKLY)
On/O Timer is set Cancel On/O Timer
Child Proof Lock set Cancel Child Proof Lock
Gas turned o at meter Turn gas on (SERVICER)