Installation Manual

88 Rinnai I-Series Condensing Boiler Solo Manual
1. Remove the boiler’s front panel by removing the four screws that secure the panel.
2. Locate the PC Board (lower le side of unit).
3. Locate the red buon on the PC Board.
4. Press and hold the red buon for ve seconds.
5. Press the Mode buon on the controller.
6. Press the (Up) or (Down) arrows to select a
parameter seng number.
Then, press the Select buon.
8. To exit parameter sengs and enter normal operaon mode, press either the red buon on
the PC Board or the Mode buon on the controller.
7. Press the (Up) or (Down) arrows to change
the selecon for the seng number (such as 30-A or
30-b).
Then, press the Select buon.
Press and Hold
Red Buon
for Five Seconds
PC Board
01-A
30-A
30-