Data Sheet
6 Rinnai Continuous Flow and Instantaneous Hot Water Warranty
Warranty Conditions
1. Warranty and the extended warranty applies to products which are manufactured on or
after the date of publication of this warranty but before the next date of publication of
this warranty.
2. All terms of this warranty are eective from date of completion of installation of the
appliance(s) and the attending service person reserves the right to verify this date by
requesting a copy of the certicate of compliance prior to the commencement of any
warranty work. Where the date of completion of installation is not known, then this
warranty will commence 2 months after the date of manufacture.
The date of manufacture is stated on the dataplate of the appliance.
Note: Certicates of compliance must be issued by the installer by law in
all States and Territories of Australia.
3. All Rinnai water heating components must be installed, commissioned, serviced,
repaired and removed in accordance with the manufacturers installation instructions,
current AS/NZS 3000, AS/NZS 3500, AS/NZS 5601, local regulations and municipal
building codes by persons authorised by local regulations to do so.
4. All Rinnai water heaters must be operated and maintained in accordance with
manufacturers operating instructions.
5. Any inspection, service, repair or replacement activities associated with warranty on
Rinnai products must be authorised by Rinnai Australia before commencement.
6. The warranty applies only to the components supplied by Rinnai. It does not apply to
components supplied by others, such as pressure limiting valves, isolating valves, non
return valves, electrical switches, pipework, electrical cables and fuses, but not limited
to these.
7. Where the appliance has not been sighted in accordance with the installation
instructions or installed such that normal service access is dicult, a service charge will
apply. If at the discretion of the attending service person, access is deemed dangerous,
service will be refused. Any work required to gain reasonable access to the appliance
will be chargeable by the attending service person (for example, removal of cupboards,
doors, walls, or the use of special equipment to move components to oor level, but not
limited to these).
8. Where a failed component is replaced under warranty, the balance of the original
appliance warranty will remain eective. The replacement part or appliance does not
carry a new warranty.
9. Rinnai reserve the right to have the installed product returned to the factory for
inspection.