Installation Guide

Rinnai Australia 24 ES Flue Installation Manual

CONNECTING HEATER EXHAUST & AIR SUPPLY

4. Use the adjustable telescopic tube of the exhaust pipe to attain the desired position of the heater, DO NOT

extend the telescopic tube beyond the indicator groove.

5. Fix the telescopic tube of the exhaust pipe in place with the flue lock. The clamp of the flue lock is

attached to the telescopic tube whilst the finger tabs are secured around the collar of the fixed flue spigot.

CONNECTING COMBUSTION AIR HOSE (AIR SUPPLY)

The combustion air hose of all Energysaver heaters is attached to the small diameter combustion air inlet.

The models 308 & 309 do not have a slide tube therefore do not need a retaining mechanism for

the slide tube. The 556, 557 and 1004 are fitted with a fixing clamp refer to Fig. 5, to stop accidental

disconnection of the slide tube. The 559 / 561 has the retaining mechanism built in to the slide tube

assembly refer Fig. 4.

This joint MUST BE properly secured in accordance with these instructions using the flue lock

provided when applicable. If the joint is not properly secured, products of combustion could

disperse into the room being heated. Which may result in a dangerous condition.

Connection of the combustion air hose for a IN-WALL installations is described refer to page 22.

Secure the combustion air hose to the combustion air inlet with cable tie supplied with the

heater.

The air hose MUST BE properly secured in accordance with these instructions for safe and reliable

operation of this heater.

The rubber cap (when fitted) is designed to fit both the left and right hand combustion air inlet and

MUST cover the air inlet not in use.

NOTE

Maximum limit of tube extension

INCORRECT over extension of tube

Collar

Note: Clamp

NOT



used on

1005 Model

CAUTION

NOTE

Models 308,309,556,557,559

and 561

Models 1004 and 1005

CAUTION