Installation manual

Rinnai New Zealand Limited Neo Installation Manual: 11906-B
02-11
15
Masonry installaons
4. Installing the heater into the replace
Apply the supplied foam seal strip to the rear of the heater. The strip is intended to form a seal
between the heater and the replace. If an adequate seal cannot be formed with this strip
another means of sealing must be used (non-combustible insulation) between the replace and
the heater body.
If using a exiliner ue, prepare the heater engine by drilling four x Ø 3.2 mm holes in the pre-
pressed dimples on the top panel of the heater. Attach the ue guide rails from the ue kit
using the supplied screws. Align the guide rails with the guide plate and slide the heater engine
into the enclosure until the guide plate is fully against the rear of the front assembly-this will
ensure the heater and ue spigot are correctly aligned.
Carefully move the appliance into the enclosure ensuring the gas supply feeds into the rear
access hole and fasten heater to the replace.
Drill
4 x Ø 3.2mm
holes
Flue guide rails
Guide rails
Guide plate
Rear of front
assembly