Installation manual

Rinnai New Zealand Limited Neo Installation Manual: 11906-B
02-11
16
Mock chimney installaons
1. Construct frame and install zero clearance box
Refer 'Enclosure dimensions' and construct frame. Assemble and install the RIB2310 zero
clearance box. Installation needs to be on a level base. If this is not done the appliance may
twist and become damaged—this will void any product warranty.
The zero clearance box is installed ush with the cladding surface.
For installations into a mock chimney a Rinnai zero clearance box and zero clearance ue kit is
required to isolate the appliance from combustible materials. Failure to meet this installation
criteria will void any product warranty.
800 mm
650 mm min.
370 mm min.
7
2. Install the ue and complete electrical connecon
The weight of the ue system should not be supported by the appliance—it should be self-
supporting. Supporting the ue is usually completed during the framing stage with ue
supports or straps within the cavity. Flue supports have been included with the ue kit to assist
with this. These are to be riveted to the ue.
Please note, a twin-skin ue requires a 25 mm clearance (from the outer ue) from
combustibles.
Combusble Material
(must be greater than 50 mm from inner flue)
Flue
Inner flue 100 mm
Outer flue 150 mm