Installation manual

Rinnai New Zealand Limited Neo Installation Manual: 11906-B
02-11
18
Freestanding installaons
1. Aach the ue spigot to the Neo engine
Using a 3.3 mm drill bit, drill through the four dimples at the rear of the back panel of the Neo
engine. Attach the ue spigot (ordered separately) with the screws provided.
Aach flue spigot
2. Assemble, posion and secure base assembly to the oor
Assemble the base assembly provided in the Neo freestander kit and place on the oor where
the Neo is to be located. Using three appropriate bolts or screws secure the base assembly to
the oor. This also acts as a seismic constraint.
The diagram below shows the base assembly for the Neo Console model. The Neo Plinth base
assembly has a pillar section attached.
Fixing posions
While the following diagrams depict the Neo Freestanding Console model, the steps to
constructing the Neo Freestanding Plinth are the same.