Installation manual
Rinnai New Zealand Limited Neo Installation Manual: 11906-B
02-11
20
Log set installaon
The granule pack and log set, consisting of ve log
pieces, comes packaged inside the appliance, you will
need to remove the glass retainer (four screws) before
installing the granules and log set. Use extreme care
when handling the log pieces, they are made from a
fragile material and will damage easily.
It is important you position the pieces in the order
shown below. Incorrect placement can create carbon build up and eect performance.
Malfunctioning due to improper log placement is not covered under warranty. The unit must
never be used with broken logs and should not be mixed with other burn media (except the
Rinnai Neo granules).
1. Check to ensure that the ports of the main
burner are clean and clear of any particles and all
packaging.
1
2. Select the thicker ‘Y’ log and t into position by
lining up the two pin holes onto the two pins of
the locating bracket that is xed to the centre of
the main burner.
2
1
3. Select the thick straight log and t onto the
metal locators on the left rear of the panel. When
correctly located this log will be touching the
burner box walls.
4. Select the thinner ‘Y’ log and t into position by
linking up the two pin holes onto the two pins of
the rst two logs. Ensure this log is seated all the
way down until it touches logs 1 and 2.
3
1
2
5. Select the longest log and t onto the metal
locators at the right rear of the panel. When
correctly located this log will be touching the
burner box walls and resting on log 1.
4
1
3
4
6. Locate the nal bowed log onto the metal locater
at the base of the right side panel and the bracket
xed to the main burner. Lean the log back until
it rests on log 4.