Installation manual
Rinnai New Zealand Limited Neo Installation Manual: 11906-B
02-11
25
Fing the frame assembly
Before tting the frame assembly, ensure that it is not scratched or damaged in any way. The
frame assembly comes packaged in one box and contains the outer frame, glass dress guard
and inner frame.
When placing the assembly down ensure it is placed on its lower edge or at. If it is
placed on its left or right edge the glass may slide out o the stand-o posts. If this
should occur ensure that the silicon rubber mounts are not dislodged when sliding the
glass back into position.
1. Before installing the frame assembly remove the two black screws that are already
positioned in the appliance. These are located on the bottom of the unit, one each side.
2. Take the inner frame and hook the slanted edge (bottom is at) over the top of the glass
retainer brackets and swing down into position onto the magnets.
3. Carefully lift the outer frame assembly complete with glass dress guard, taking care not
to tilt it on its edge as the glass may slide out o the stand-o posts. Come in close to the
heater and plug in the CAT cable into the control panel.
NOTE
Control panel
plug
CAT cable
Posion of the CAT cable and control panel plug (step 3)