Installation manual

Rinnai Australia 7 Ultima II Operation Manual
HOW TO OPERATE THE HEATER
MODES TO DELIVER COMFORT AND ECONOMY
Your appliance has several MODE settings to choose from. The factory default mode is GAS. If the
mode is not adjusted this will be the default setting the next time the appliance is used.
As a room is warmed, the walls and ceilings are also warmed, making one feel a little warmer than
when the ceilings and walls were cold, even though the room temperature is the same. The economy
mode prevents discomfort from overheating and saves energy.
GAS MODE
Gas combustion in this mode is continuous and will adjust automatically to maintain the set
temperature. This is the factory default mode for the appliance.
GAS / ECON MODE (ECONOMY MODE)
In this mode, once the set temperature has been maintained for a period of 30 minutes, the comfort
control system will progressively lower the set temperature by 2°C over a period of 60 minutes. When
GAS / ECON mode is selected, gas combustion is continuous and will adjust automatically to maintain
the set temperature minus 2°C.
GAS / ECON / AUTO OFF MODE
In this mode, once the set temperature has been maintained for a period of 30 minutes, the comfort
control system will progressively lower the set temperature by 2°C over a period of 60 minutes. When
GAS / ECON / AUTO OFF mode is selected, gas combustion will start and stop automatically to
maintain the set temperature minus 2°C.
SELECTING MODES
The current operation mode is displayed on the digital display and the SET button is used to
select which mode the heater will use during operation.
The select a different mode press the SET button whilst the appliance is in operation, this will cycle
the heater through the available modes as follows:
During operation in GAS / ECON mode the current room
temperature (CURR ) may be lower than the set temperature
(SET ), however this is normal.
During operation in GAS / ECON / AUTO OFF mode the current room
temperature (CURR ) may be lower than the set temperature
(SET ), however this is normal.
The MODE selected will be stored in the memory of the microcomputer. if the MODE
is not changed further it will be available as the initial setting when the appliance is
next used.
NOTE
1112
11
12
NOTE
1112
11
12
14
15
su
--:-- am
timeroff
GAS ECON
weehen0
AM PM
AUTO OFF
14
15
15
GAS ECON
AUTO OFF
GAS ECON
AUTO OFF
GAS ECON
AUTO OFF
NOTE