Installation manual

Rinnai Australia 2 Ultima II Operation Manual
FEATURES
The Rinnai Ultima II is one of the most efficient gas space heaters available in Australia.
This has been achieved by combining good design with the latest technology, making the heater
both highly efficient and easy to use.
Downflow Convection operation and large capacity fan ensures effective heating to all parts of the
room and reduces stratification.
30 MJ/h input, large enough to suit most domestic applications.
Ignition is fully automatic and the burner is continuously monitored by an electronic flame failure
system. If the flame is extinguished during operation, the gas supply is shut off immediately.
Electronic temperature controls ensure that the room stays at the temperature you have selected.
Electronic dual ON and OFF timers.
Filters to protect the burner from dust and lint.
Automatic fan switch to turn the fan on and off and match the fan speed to the heat input at all
times, increasing efficiency and comfort.
Overheat switches avoid hazards should the appliance overheat.
SAFETY
Failure to comply with these instructions could result in a fire or explosion, which
could cause serious injury, death or property damage.
Improper installation, adjustments, service or maintenance can cause serious injury,
death or property damage. Such work must be performed by an authorised person.
The appliance must be installed in accordance with the local gas and electrical
authority regulations.
This appliance must not be installed where curtains or other combustible materials
could come into contact with it. In some cases curtains may need restraining.
This appliance discharges a large volume of
warm air at low level to provided even heat
distribution.
Some nylon carpets contain dyes which may
be affected by the warm air flow.
Heat emanating from the front of this
appliance may over time affect the appearance
of some materials used for flooring such as
carpet, vinyl, cork or timber. This effect may
be amplified if the air in the room contains
cooking vapours or cigarette smoke. To avoid
this possibility, it is recommended that a mat
be placed in front of the appliance, extending
at least 750 mm in front of it.
The appliance is not intended for use by young children or infirm persons without
supervision.
Young children should be supervised to ensure they do not play with the
appliance.
If the supply cord is damaged or requires replacing, it must be replaced by the
manufacturer or the manufacturer's agent or similarly qualified person in order to
avoid a hazard.
CAUTION
150mm
1000mm
150mm
150mm
The above diagram shows the clearances required
around this heater whilst in operation