Installation manual

Rinnai 4 RF1800 OIM
SAFETY
IMPORTANT
DO NOT sit or lean against the heater.
DO NOT post or allow children to post articles into the heater.
DO NOT cover or place articles on this heater.
DO NOT operate / install this heater in areas where painting is taking place, or in places such as
hairdressing salons, where there may be uff and dust, and where aerosols are used.
DO NOT place articles on or against this appliance.
DO NOT use or store ammable materials near this appliance. Keep ammable materials away from
heater.
Combustible materials MUST NOT be placed where the heater could ignite them.
DO NOT spray aerosols in the vicinity of this appliance while it is in operation. Most aerosols contain
ammable substances which can be a hazard if used near this appliance when it is in use.
DO NOT use power boards or double adaptors to operate this appliance. The heater MUST NOT be
located below a power socket-outlet.
DO NOT place containers of liquid on top of the heater. Water spillage can cause extensive damage
to the appliance and create an electrocution hazard.
DO NOT CONNECT TO AN LPG GAS CYLINDER INDOORS.
Turn the heater ‘OFF’ when not in use.
DO NOT unplug the heater while it is in operation.
When the heater is operated for the rst time or after long periods of non use a slight odour may be
emitted, this is normal. However if odours persist switch ‘OFF’ the appliance and contact Rinnai.
Appliances incorporating a live fuel effect and designed to operate with luminous ames, may exhibit
slight carbon deposits.
This is primarily a decorative appliance and has not been designed as a space heater.
NOT INTENDED FOR FIREPLACE INSERT
WHAT TO DO IF YOU SMELL GAS
DO NOT try to light any appliances.
DO NOT touch any electrical switches: do not use any phone in your building
Immediately close the shut-off valve at the gas meter or bottles
Call an authorised service technician
SAFETY DEVICES
Electrical Fuse:
The electrical circuits are protected by a fuse. When the fuse blows, the heater will not operate. The fuse must be
replaced by an authorised person.
Flame Failure Sensing System:
This device automatically cuts off the gas supply to the heater in the event of a ame failure.
Power Failure:
In the event of a power failure or power cut, the gas valves will automatically close. Refer to “Electrical Supply” on
page 10 for further details.